فلو متر التراسونیک ۳ اینچ اتصال فلنجی
DN80 Digital Sandwich Ultrasonic Water Flow Meter for Agricultural irrigation with IP68 Protection RS485& Mbus Output
The T3 series ultrasonic water meter is a new generation of smart water meter designed for agricultural irrigation and water resource monitoring. It is an all-plastic smart water meter with nylon as the main material. It is installed in the pipe by clamping the meter body which is only 50 mm in thickness between the two flanges of the pipe.
The new generation of DTI-T3 series ultrasonic water meter uses a technology similar to that of FLEXIM company’s ultrasonic flowmeter. The transit time difference is obtained through correlation calculation of captured signal waveform, thus featuring high precision, low drift, anti-interference, stability and reliability.
The smart water meter also uses a signal acquisition hardware with a dynamic range of 30dB, so it can resist medium scaling inside the pipe and is suitable for measurement of muddy water with sediments.
Communication protocol: MBus, Mdbus(RS485)
Range ratio: 40:1,100:1, 200:1
Standard: ISO4064 class B (class 2), 2% accuracy within the range
Protection grade: IP68
Flow rate range： 0.01m/S~8m/S
Low initial velocity to 1 mm/s, low zero drift (value to be determined)
Flow unit selectable: cubic meter, American gallon, liter, cubic foot, acre foot
Display: multiple lines display simultaneously 9-bit long accumulator, 6-bit long instantaneous
quantity, signal strength, battery status, flow direction, fault, communication status, etc
Pipe diameter：This link is DN80. (DN50，DN65, DN100， DN125, DN150 are Optional, if you need, please contact me)
Power supply: 3.6V4Ah disposable lithium battery power, >6 years of service life
Data retention time after power failure: 10 years
Technology applied: single channel ultrasonic principle, waveform analysis, correlation calculation, signal amplitude adaptive.
[6:13 pm, 15/08/2022] Kazem Oliyaei: Description:
The inflator will stop automatically when it is inflating. You only need to press the start button and you can leave it alone, saving time and effort.
The digital display will become visible as long as the inflator is inserted into the tire valve, and the tire pressure will be detected.
Made of ABS and metal, it has high hardness and long service life.
Its length is 20.3cm and its width is 13.2cm.
It is used to inflate tires.
Item Name: Inflator
Supply Voltage: 12V
Power Cord Length: 300cm
Air Volume: 25L/min
Cylinder Standard: 1: Vehicle Pointer, 2: Vehicle Digital Display, 3: Charging Digital Display
Inflatable Tube Length: 53cm
Maximum Power: 120W
Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.
1 X Air Pump
4 X Accessories