کنترلر دما با سنسور ترموکوپل تایپ K
The product has a total of four buttons, button plus, button minus, SET (setting button), reset button. There are two sets of digital tubes showing the actual temperature and the set temperature respectively. All parameters are automatically remembered after 5 seconds of setting.
Red digital tube: actual temperature
Blue digital tube: set temperature
Button plus: Increase the set temperature
Button minus: Decrease the setting temperature
Restore factory settings: Press and hold the button plus button for more than 5s at the same time, the system will restore the original settings data.
Set button (SET):
1. Short press SET, set the temperature to add 50 °C each time, the user can quickly press SET to quickly set to the vicinity of the preset temperature value, and then fine-tune to the preset temperature by pressing the button.
2. Press and hold SET to enter the parameter setting options. There are several parameters of P00~P05 for the user to set. After entering the parameter interface, press SET shortly to switch P00~P05. Under the corresponding parameters, the corresponding data is added or subtracted by pressing the button, and the automatic memory data is returned to the display interface after the system is completed for 10 seconds.
P00: H heating mode / C cooling mode
P01: Temperature difference backlash (0~500°)
P02: Temperature correction(-10~10°)
P03: Maximum temperature alarm value (500°)
P04: Minimum temperature alarm value (-60°)
P05: Data lock (ON/OFF)
Voltage: DC 12V;
Output: 10A relay
Temperature control range: -60~500°
Temperature accuracy: 1°
Refresh rate: 0.5S
Shell material: ABS
Installation size: 74x39mm/2.91x1.54inch
Cable length: 42cm
1.Please allow 0-2mm error due to manual measurement. pls make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
1 x Digital Temperature Controller
1 x K-type M6 Thermocouple